The Ox64: An $8 RISC-V Board's Surprisingly Complex Setup
The Ox64 is an $8 RISC-V-based computer with three distinct cores capable of running a full Linux kernel. Despite this capability, ethernet, WiFi, and SD-card functionality were not operational at the time of writing.
Unlike Arduino, ESP32, Stamp-C3, and rPi Pico boards, the Ox64 cannot be programmed via USB. Instead, it requires UART serial connections through GPIO14 and GPIO15. Initial attempts using a CH340G adapter failed during handshake. The author resolved this by deploying an RP2040 device running as a serial bridge—specifically an Adafruit KB2040 model running picoprobe. The standard DevCube flashing tool either crashed on Ubuntu with Wayland or refused to communicate. Switching to bflb-mcu-tool and modifying its source code to remove DTR and RTS signal handling finally enabled successful flashing.
After flashing the low_load_bl808_m0.bin bootloader, the Ox64 produced output confirming memory initialization and core startup, demonstrating the device could respond to commands. The complete Linux installation remained incomplete.
Read the full article
Continue reading at Hacker News →This is an AI-generated summary. Read the original for the full story.